Specifications

AT command set for XX Siemens mobile phones and modems
_________________________________________________________________________________________
_________________________________________________________________________________________
Document No.: A30880-A10-A001-XX-
D376
Revision: Master R75
Revision Date: 29. September, 2004
106
128
dedicated PAD access
X
combination of some of the above classes, e.g. 255
regroups all classes and 5 regroups Voice and FAX
<status
> 0
Off
1
On
AT^SLNG
AT^SLNG Language settings
Test command Response:
AT^SLNG=?
^SLNG: (list of supported languages <lng
>s)
Parameter:
<lng
>
Integer; language coded according to GSM 03.38 ( see [5]) or
mobile-specific language (>100)
Read command Response:
AT^SLNG?
^SLNG: <lng>
Write command
AT^SLNG=<lng>
Response:
OK/ERROR/+CME ERROR
AT^SMGL
AT^SMGL
List SMS (without status change from unread to read)
Revision according to 3GPP TS 27.005
Test command Response
AT^SMGL=?
^SMGL: (list of supported <stat
>s)
Parameter:
<stat
>
0
REC UNREAD received unread messages (default)
1
REC READ received read messages
2
STO UNSENT stored unsent messages
3
STO SENT stored sent messages
4
ALL all messages
Write command
AT^SMGL [=<stat>]
Response:
If PDU mode (+CMGF=0) and command is successful:
^SMGL: <index
>,<stat>,[<alpha>],<length>
<CR><LF><pdu
>
[<CR><LF>^SMGL: <index
>,<stat>,[<alpha>],< length>
<CR><LF><pdu
>
[...]]
Parameter:
<stat
>
See Test command
<pdu
>
The PDU begins with the service-center address (according to GSM
04.11, see [9]), followed by the TPDU according to GSM 03.40 (see
[3]) in hexadecimal format
otherwise:
+CMS ERROR: <err>