Specifications

AT command set for XX Siemens mobile phones and modems
__________________________________________________________________________________________
Document No.: A30880-A10-A001-XX-
D376
Revision: Master R75
Revision Date: 29. September.2004
107
AT^SMGO
AT^SMGO SMS overflow indicator
Test command Response:
AT^SMGO=?
^SMGO: (list of supported <n
>s)
OK/ERROR/+CMS ERROR
Parameter:
<n
> 0
Disable
1
Enable
Read command Response:
AT^SMGO?
^SMGO: <n>,<mode>
OK/ERROR/+CMS ERROR
Parameter:
<n
>
See Test command
<mode
> 0
Space still available
1
SMS storage full (The "SM" and "ME" storages are full, i. e.
the "MT" storage is full. See AT+CPMS command.)
2
A message is queued in the (network-based) Message
Service Centre (MSC) to be forwarded/delivered to the
mobile phone (e.g., a Class 2 message is queued but the
"SM" storage is full; or any kind of message is queued but
every storage is full )
Write command Response
AT^SMGO=<n>
OK/ERROR/+CMS ERROR
Parameter:
<n
>
See Test command
<mode
>
See Test command
Unsolicited result code:
^SMGO: <mode>
Notes
1) Indication during data transfer via break (100ms).
2)
Incoming short messages with message class 2 (refer <dcs> GSM
03.38, see [5]) will be stored in "SM" storage only. Therefore, AT^SMGO:
2 indication can occur without a preceding AT^SMGO: 1 indication.
AT^SMGR
AT^SMGR
Read SMS (without status change from unread to read)
Syntax identical with AT+CMGR
Test command Response
AT^SMGR=?
OK
Write command
AT^SMGR=<index>
Response:
If PDU mode (+CMGF=0) and command are successful:
AT^SMGR: <stat
>,[<alpha>],<length><CR><LF><pdu>
Parameter:
<pdu
>
The PDU begins with the service-center address (according to
GSM 04.11, see [9]), followed by the TPDU according to GSM
03.40 (see [3]) in hexadecimal format
otherwise:
+CMS ERROR: <err>
<stat
>
0
REC UNREAD received unread messages (default)
1
REC READ received read messages
2
STO UNSENT stored unsent messages