Specifications

AT command set for XX Siemens mobile phones and modems
_________________________________________________________________________________________
_________________________________________________________________________________________
Document No.: A30880-A10-A001-XX-
D376
Revision: Master R75
Revision Date: 29. September, 2004
116
Delete Action
If no parameters are provided, every setting will be deleted.
If no <key
> parameter is entered then all settings of this
application are deleted
Otherwise just the setting corresponding to the key will be
deleted.
Set Action
All parameters are mandatory.
Get Action
Optional application and <key
> parameters
If no <key
> parameter is entered then all settings of this
application are retrieved, otherwise just the setting
corresponding to the <key
> will be retrieved.
Example Note:
The <fullname> parameter should be specified according to the character
setting defined in the AT+CSCS command.
Example: “A:\Sounds\jump.mid”
In GSM character set, this string is different to ANSI character set (standard)
and thus the Backslash character must be passed as two characters:
the extension table character and a slash.
The extension table character has value 1B and the following character “/” has
value 2F.
In UCS2 character set, there is no problem since “\” is defined as value 005C.
Note: String case insensitive (Upper or Lower case)
AT^SSTK
AT^SSTK SIM Toolkit
Test command Response:
AT^SSTK=?
^SSTK: <profile
>
Parameter:
<profile
>
ME profile according to GSM 11.14
Write command
AT^SSTK=<length>[,<mode>]<CR>
PDU is given:
<ctrl-Z/ESC>
Response:
OK/ERROR/+CME ERROR
Parameter:
<length
>
Length of PDU in bytes, with a maximum PDU length of 255
bytes
<mode>
0
Single command
1
Sequence of commands
<pdu
>
SIM Toolkit commands,
see GSM 11.14
Unsolicited result code
^SSTK: <data>
AT^SVMC
AT^SVMC Voice Memo Control
Test command Response:
AT^SVMC =?
^SVMC: (list of <action
>s),<number>,<time>,<nlength>
OK/ERROR/+CME ERROR