Specifications

AT command set for XX Siemens mobile phones and modems
__________________________________________________________________________________________
Document No.: A30880-A10-A001-XX-
D376
Revision: Master R75
Revision Date: 29. September.2004
15
Command Function
AT&F[0] Resets all current parameters of the following AT commands to their factory
profile:
ATE, ATQ, ATV, AT&\Q, AT&C, AT&D, AT&S , AT+VTS, ATX
AT+CAOC, AT+CBST, AT+CCWA, AT+CEER, AT+CLIP, AT+CMEC,
AT+CMEE, AT+CMER, AT+CNMI, AT+COLP, AT+COPS, AT+CPOL,
AT+CPMS, AT+CPBS, AT+CR,, AT+CRC, AT+CREG, AT+CRLP,
AT+CSCS, AT+CSMS, AT+CSSN, AT^SACM, AT^SCKS, AT^SMGO,
S parameters
If GPRS is supported then also the following GPRS commands are affected:
AT+CGAUTO, AT+CR, AT+CGEREP, AT+CGREG
O
nly for Master Document:
AT^SACD, AT^SADT
Any existing connections will be terminated. No other commands are
accepted on the same command line.
AT&\N
No action (\N2 - \N6)
\N2
\N3
\N4
\N5
\N6
AT&\Q<n
Local flow control selection (DTE ↔ DCE); can be customized
<n> can take one of the following values:
0
Disable flow control
1
XON-XOFF software flow control
2
CTS only flow control
3
RTS/CTS flow control
AT\V[n] Modem command
0
No /REL or /RLP appendix with the CONNECT message
1
/REL or /RLP appendix with the CONNECT message
AT+GMI
request TA manufacturer identification (see AT+CGMI)
AT+GMM
request TA model identification (see AT+CGMM)
AT+GMR
request TA revision identification (see AT+CGMR)
AT+GSN
request TA serial number identification (see AT+CGSN)
Table 2-7: Generic TA control commands supported according to ITU-T V.25