Specifications

AT command set for XX Siemens mobile phones and modems
_________________________________________________________________________________________
_________________________________________________________________________________________
Document No.: A30880-A10-A001-XX-
D376
Revision: Master R75
Revision Date: 29. September, 2004
20
OK/ERROR/+CME ERROR
Parameter:
<keys
>
string of characters representing keys (see section 5.5 for a list of
implemented keys)
<time
> 0...255
3
time in tenths of seconds (0.1 seconds) that each
key must be pressed
Default: = 0.3 sec
<pause
> 0...255
length of pause in tenths of seconds (*0.1
seconds) that may elapse between two key
presses
Note:
Keypad handling has to be enabled prior to executing this command by means of
the AT+CMEC=2 command.
AT+CSCS
AT+CSCS Select TE character set
Test command Response:
AT+CSCS=?
+CSCS: (list of supported <chset
>s)
OK
Parameter:
<chset
>
String; determines which TE character set is used
GSM
GSM character set is used
UCS2
UCS2 character set is used
Read command Response:
AT+CSCS?
+CSCS: <chset
>
OK/ERROR/+CME ERROR
Parameter:
<chset
>
See Test command
Write command
AT+CSCS=[<chset
>]
Response:
OK/ERROR/+CME ERROR
Parameter:
<chset
>
See Test command
AT+GSN
AT+GSN Output the serial number (IMEI)
Test command Response:
AT+GSN=?
OK/ERROR/+CME ERROR
Execute command Response:
AT+GSN
<sn
>
Parameter:
<sn
>
IMEI of the telephone
AT+WS46
AT+WS46 Select wireless network
Test command Response:
AT+WS46=?
(list of supported <n
>s)
OK/ERROR/+CME ERROR
Parameter:
<n>
Integer; WDS side stack
12
GSM digital cellular