Specifications

AT command set for XX Siemens mobile phones and modems
_________________________________________________________________________________________
_________________________________________________________________________________________
Document No.: A30880-A10-A001-XX-
D376
Revision: Master R75
Revision Date: 29. September, 2004
26
Test command Response:
AT+CLCC=? OK
Execute command Response:
AT+CLCC
[+CLCC:
<id
1>,<dir>,<stat>,<mode>,<mpty>,<number>,<type>,<alpha>,<li
ne>][<CR><LF>
+CLCC: <id
2>,<dir>,<stat>,<mode>,<mpty>,
<number
>,<type>,<alpha>,<line> [...]]]
OK/ERROR/+CME ERROR
Parameter:
<id
>
Indicates the call identification number as described in subclause
4.5.5.1 of the GSM 02.30 document [4];
0 ..
65535
this number (integer) can be used in AT+CHLD command
operations
<dir
>
Specifies whether the call is mobile originated or mobile terminated
0
mobile originated (MO) call
1
mobile terminated (MT) call
<stat
>
Indicates the state of the call
0
active
1
held
2
dialing (MO call)
3
alerting (MO call)
4
incoming (MT call)
5
waiting (MT call)
<mode
>
Indicates the bearer/teleservice
0
voice
1
data
2
fax
3
voice followed by data, voice mode
4
alternating voice/data, voice mode
5
alternating voice/fax, voice mode
6
voice followed by data, data mode
7
alternating voice/data, data mode
8
alternating voice/fax, fax mode
9
unknown
<mpty
>
Specifies whether or not the call is of multiparty (conference) call
parties
0
No (no multiparty (conference) call)
1
Yes (multiparty (conference) call)
<number
>
string type phone number in format specified by <type>
<type
>
type of address octet in integer format
<alpha
>
string type alphanumeric representation of <number>corresponding
to the entry found in phonebook, character set according to the
AT+CSCS command
<line
>
1
(Master copy only:)
Default line
2
subscribed alternate line service (ALS); line 2
AT+CLCK
AT+CLCK Switch locking on and off
Revision to 3GPP TS 27.007 according to CR TDOC ETSI/SMG4 187/96