Specifications

AT command set for XX Siemens mobile phones and modems
__________________________________________________________________________________________
Document No.: A30880-A10-A001-XX-
D376
Revision: Master R75
Revision Date: 29. September.2004
37
20x,31x,33x,34x,51x,53x,54x)),
("GPRS coverage",(0,1)),
("callsetup",(0-3))
OK/ERROR/+CME ERROR
Parameter:
<battchg>
0 .. 5
battery charge level (0 = empty, 5 = full)
<signal>
0 .. 5
quality of signal (0 = not detectable , 5 = good)
<service>
0
Service not available
1
Service available
<message> 0
No unread message in memory storage
1
At least one unread message in storage
<call> 0
No call in progress or established
1
call in progress or established
<roam>
0
Home network, no roaming
1
roaming
<smsfull> 0
memory locations are available
1
a short message memory storage in the MT has
become full
<call status>
0
There was no call since reporting was enabled
10x
Call number x was released
11x
A MOC with call number x has started dialing
12x
A MOC with call number x is ringing at B-party
13x
A MTC with call number x is ringing
14x
Call number x was established
15x
Call number x is waiting
16x
Call(s) was/were swapped; x is call number of the
call on hold. If no call is held, x = 0.
170
A call is now in multiparty. No call number provided.
180
A call was transfered. No call number provided.
19x
Call number x was set on hold by B-party
20x
Call number x was set to active by B-party
21x
CCBS is available for this call
Numbers 31-54 only for Master Doc. (K1)
31x
A Data-MOC call number x has been started
33x
A Data-MTC with call number x is ringing
34x
A Data call number x was established
51x
A Data-MOC call number x has been started
53x
A Data-MTC with call number x is ringing
54x
A Data call number x was established
<GPRS coverage>
0
No GPRS coverage available or coverage unknown
1
GPRS coverage available
<callsetup> 0
No call setup in progress
1
MTC is waiting or ringing
2
A MOC was initiated
3
A MOC is ringing at B-party
Remark:
The test command returns the supported values which are issued as unsolicited result code of each
indicator. It does NOT return the supported values to set an indicator.
Each indicator can be switched on (1) or off (0).
Read command Response: