Specifications

AT command set for XX Siemens mobile phones and modems
__________________________________________________________________________________________
Document No.: A30880-A10-A001-XX-
D376
Revision: Master R75
Revision Date: 29. September.2004
39
2
MT can be operated from both MT keypad and TE
<disp> 0
only MT can write to its display
<ind> 0
only MT can set the status of its indicators
Read command Response:
AT+CMEC?
+CMEC: <keyp>,0,0
OK/ERROR/+CME ERROR
Parameter:
<keyp>
See Test command
Write command
AT+CMEC=[<keyp>[,0[,0]]]
Response:
OK/ERROR/+CME ERROR
Parameter:
<keyp>
See Test command
AT+CMER
AT+CMER Mobile Termination control mode
Test command Response:
AT+CMER=?
+CMER: (list of supported <mode
>s),(list of supported <keyp>s),(list of
supported <disp
>s),(list of supported <ind>s),(list of supported <bfr>s)
OK/ERROR/+CME ERROR
Parameter:
<mode
> 0
buffer unsolicited result codes in the TA; if TA result code
buffer is full, codes the oldest ones are discarded
1
discard unsolicited result codes when TA-TE link is reserved
(e.g. in on-line data mode); otherwise forward them directly to
the TE
2
buffer unsolicited result codes in the TA when TA-TE link is
reserved (e.g. in on-line data mode) and flush them to the TE
after reservation; otherwise forward them directly to the TE
3
same as “2”.
This input for the bluetooth carkit is acceptable but the
behaviour is same as mode=2
<keyp
> 0
no keypad event reporting
1
keypad event reporting using result code +CKEV:
<key>,<press>, where <key> indicates the key (refer
values defined in table for AT+CKPD) and <press> whether
the key is pressed (1) or released (0). Only key pressings
that are not caused by AT+CKPD are indicated by the TA to
the TE
2
keypad event reporting using result code +CKEV:
<key>,<press>. All key pressings shall be directed from
TA to TE
<disp> 0
no display event reporting
<ind> 0
no indicator event reporting
1
indicator event reporting using result code +CIEV:
<ind>,<value>. <ind> indicates the indicator order
number (as specified for AT+CIND) and <value> is the new
value of indicator. Only those indicator events, which are not
caused by AT+CIND shall be indicated by the TA to the TE
2
indicator event reporting using result code +CIEV: