Specifications
AT command set for XX Siemens mobile phones and modems   
_________________________________________________________________________________________ 
_________________________________________________________________________________________ 
Document No.:  A30880-A10-A001-XX-
D376 
Revision: Master R75     
Revision Date:  29. September, 2004     
  48 
2.3.5  Extensions of Hayes Standard commands for GPRS 
This chapter describes all the extensions of the Hayes Standard commands for GPRS. 
Command  Function 
ATD*<GPRS_SC>[*[<called_address>] [*[<L2P>][*[<cid>]]]]# 
  Request GPRS service 
<GPRS_SC> 
GPRS Service Code a digit string (value 99) 
<called_address> 
a string that identifies the called party in the 
address space 
<L2P> 
a string which indicates the layer 2 protocol 
<cid> 
a digit string which specifies a particular PDP 
context definition. The cid has to be defined 
by using the AT+CGDCONT command 
The dial command responds with CONNECT or ERROR 
ATD*<GPRS_SC_IP>[*<cid>]# 
Request GPRS IP service 
<GPRS_SC_IP> 
GPRS Service Code a digit string (value 98) 
<cid> 
a digit string which specifies a particular PDP 
context definition. The cid has to be defined by 
using the AT+CGDCONT command 
The dial command responds with CONNECT or ERROR 
ATO  Return to on-line data state 
ATS0 
Automatic answer. The command may be used to turn off (n=0) and on (n>0) 
the automatic response to a network request for a PDP context activation. 
ATS3 Termination character 
ATS4  Response formatting character 
ATS5  Command line editing character 
ATS7  Wait for carrier after dialing (in seconds). 
2.3.6  Commands for GPRS 
This section provides the descriptions of commands related to GPRS. 
AT+CGACT
AT+CGACT 
PDP context activate or deactivate 
Test command  Response 
AT+CGACT=? 
+CGACT: (list of supported <state
>s) 
OK/ERROR/+CME ERROR 
Parameter 
<state
> 
indicates the state of PDP context activation 
0 
deactivated 
1 
activated 
Read command  Response 
AT+CGACT? 
+CGACT: <cid
>,<state>[<CR><LF> 
+CGACT: <cid
>,<state>...]] 
OK/ERROR/+CME ERROR 
Parameter 
<cid
> 
numeric PDP Context Identifier 










