Specifications

AT command set for XX Siemens mobile phones and modems
__________________________________________________________________________________________
Document No.: A30880-A10-A001-XX-
D376
Revision: Master R75
Revision Date: 29. September.2004
63
Write command
AT+CGQREQ=[<cid>[,<precedence>[,<delay>[,<reliability>[,<peak>[,<mean>]]]]]]
Response:
OK/ERROR/+CME ERROR
Parameter:
<cid
>
See Read command
<precedence
>
See Test command
<delay
>
See Test command
<reliability
>
See Test command
<peak
>
See Test command
<mean
>
See Test command
AT+CGPADDR
AT+CGPADDR Show PDP address
Test command Response:
AT+CGPADDR=?
+CGPADDR: (list of defined <cid
>s)
OK/ERROR/+CME ERROR
Parameter:
<cid
>
numeric PDP Context Identifier
Write command
AT+CGPADDR=[<cid> ,[< cid> [,<cid> [,…]]]]
Response:
+CGPADDR: <cid
>,<PDP addr>[<CR><LF>
+CGPADDR: <cid
>,<PDP addr>[...]]
OK/ERROR/+CME ERROR
Parameter:
<cid
>
See Test command
<PDP addr
>
IP address of PDP
AT+CGREG
AT+CGREG GPRS network registration status
Test command Response:
AT+CGREG=?
+CGREG: (list of supported <n
>s)
OK/ERROR/+CME ERROR
Parameter:
<n
> 0
Suppresses the unexpected network status messages
1
Enable the unexpected network status messages
Unsolicited result code
OK/ERROR/+CME ERROR
Read command Response:
AT+CGREG?
+CGREG: <n
>,<stat>
OK/ERROR/+CME ERROR
Parameter:
<n
>
See Test command
<stat
>
Status
0
Not registered, not currently searching
1
Registered home network
2
Not registered, but currently searching
3
registration denied by network
4
Unknown
5
Registered, roaming