Specifications

AT command set for XX Siemens mobile phones and modems
__________________________________________________________________________________________
Document No.: A30880-A10-A001-XX-
D376
Revision: Master R75
Revision Date: 29. September.2004
75
MT
combination of "ME" and "SM" storages
<mem3
>
Memory in which received messages are preferred to be stored,
if routing to TE is not set
(see AT+CNMI command with parameter <mt>=2)
SM
SIM message storage
ME
Mobile Equipment message storage
MT
combination of "ME" and "SM" storages
Read command Response:
AT+CPMS?
+CPMS:
<mem
1>,<used1>,<total1>,<mem2>,<used2>,<total2>,<mem3>,<use
d3>,<total3>
Parameter:
<mem
x>
Memory from which messages are read and deleted, x=1..3
<used
x>
Number of messages currently in <memx>
<total
x>
Total number of messages that can be stored in <memx>
Write command
AT+CPMS= <mem1>[,<mem2>[,<mem3>]]
Response:
+CPMS: <used1
>,<total1>,<used2>,<total2>,<used3>,<total3>
OK/ERROR/+CMS ERROR
Parameter:
<mem1
>
See Test command
<mem2
>
See Test command
<mem3
>
See Test command
Note
Incoming short messages with message class 2 (see GSM 03.38, [5] ) will be
stored in the "SM" storage only. Therefore, the AT^SMGO:2 indication (see
AT^SMGO command) can occur without a preceding AT^SMGO:1 indication.
AT+CSCA
AT+CSCA Address of the SMS service centre
Test command Response:
AT+CSCA=?
OK/ERROR/+CME ERROR
Read command Response:
AT+CSCA?
+CSCA: <sca
>,<tosca>
Parameter:
<sca
>
Service center address in string format
<tosca
>
Service center address format
Write command
AT+CSCA=<sca>[,<tosca>]
Response:
OK/ERROR
AT+CSCB
AT+CSCB Select cell broadcast messages
Test command Response:
AT+CSCB=?
+CSCB: (list of supported <mode
>s)
Parameter:
<mode
> 0
Accepts messages that are defined in <mids> and
<dcss>
1
Does not accept messages that are defined in <mids> and
<dcss>
Read command Response: