Specifications

AT command set for XX Siemens mobile phones and modems
_________________________________________________________________________________________
_________________________________________________________________________________________
Document No.: A30880-A10-A001-XX-
D376
Revision: Master R75
Revision Date: 29. September, 2004
76
AT+CSCB?
+CSCB: <mode
>,<mids>,<dcss>
Parameter:
<mode
>
See Test command
<mids
>
String type; combinations of CBM message IDs
<dcss
>
String type; combinations of CBM data coding schemes
Write command
AT+CSCB=[<mode>[,<mids>[,<dcss>]]]
Parameter:
<mode>
See Test command
<mids>
String type; combinations of CBM message IDs
<dcss>
String type; combinations of CBM data coding schemes
AT+CSMS
AT+CSMS Selection of message service
Revision according to 3GPP TS 27.005 Version 5.0.0
Test command Response:
AT+CSMS=?
+CSMS: (list of supported <service
>s)
Parameter:
<service
> 0
GSM 03.40 [6] and 03.41 [7]
1
GSM 03.40 [6] and 03.41 [7] and compatibility of the AT
command syntax for phase 2+
Note: Deactivating phase 2+ compatibility is only possible if the
direct output of short messages AT+CNMI=1,2 or
AT+CNMI=1,3 is not activated. If necessary, the latter should
be deactivated first
Read command Response:
AT+CSMS?
+CSMS: <service
>,<mt>,<mo>,<bm>
Parameter:
<service
>
See Test Command
<mt
>
Mobile terminated messages
1
Type supported
<mo
>
Mobile originated messages
1
Type supported
<bm>
Broadcast type messages
1
Type not supported
Write command
AT+CSMS= <service>
Response:
+CSMS: <mt
>,<mo>,<bm>
OK/ERROR/+CME ERROR
Parameter:
<service
>
See Test Command
2.5 Modem commands
This section provides the descriptions of modem commands.
AT+CBST
AT+CBST Select bearer service type
Selects the bearer service <name> with data rate <speed> and the connection element <ce> to be
used when data calls are originated.
Test command Response: