Specifications

AT command set for XX Siemens mobile phones and modems

__________________________________________________________________________________________

Document No.: A30880-A10-A001-XX-

D376

Revision: Master R75

Revision Date: 29. September.2004

*) Note:

Only the default value needs to be implemented.

Use test command to check which parameter values are in fact possible!

Read command Response:

AT+FDIS?

<cdis> OK

Parameter:

See Test command

Write command

AT+FDIS=<VR>,<BR>,<WD>,<LN>,<DF>,<EC>,<BF>,<ST>

Response:

+FDIS: (list of <VR>s), (list of <BR>s), (list of <WD>s), (list of <LN>s), (list of

<DF>s), (list of <EC>s), (list of <BF>s), (list of <ST>s)

Parameter:

See Test command

AT+FDR

AT+FDR Begin or continue phase C data reception

Used for FAX class 2 only

This command initiates transition to Phase C data reception

Execute command Response:

AT+FDR

CONNECT/OK/ERROR

AT+FDT

Data Transmission

Used for FAX class 2 only

This command requests the ME to transmit a Phase C page. When the ME is ready to accept Phase

C data, it issues the negotiation responses and the CONNECT result code to the application.

In Phase B, this command releases the ME to proceed with negotiation, and releases the DCS

message to the remote station.

In Phase C, this command resumes transmission after the end of a data stream transmitted before.

Execute command Response

AT+FDT

CONNECT

Parameter:

<dt>

list of <df>s, <vr>s, <wd>s, <ln>s

Data compression Format

)

1-D modified Huffman

1 2-D modified read

2 2-D uncompressed mode