Specifications

AT command set for XX Siemens mobile phones and modems
_________________________________________________________________________________________
_________________________________________________________________________________________
Document No.: A30880-A10-A001-XX-
D376
Revision: Master R75
Revision Date: 29. September, 2004
88
AT+FOPT
AT+FOPT Set bit order independently
Used for FAX class 2 only
Read command Parameter:
AT+FOPT?
<opt>
0
non-standard
1
standard
Write command
AT+FOPT=<opt> Model-specific command to set bit order independently of the understanding
which is "mirrored" and which is direct.
Response:
OK
Parameter:
<opt>
1
see Read command
AT+FPHCTO
AT+FPHCTO DTE Phase C Response Timeout
Used for FAX class 2 only
Determines how long the DCE will wait for a command after reaching the end of data when
transmitting in Phase C. When time-out is reached, the DCE assumes that there are no more pages
or documents to send
Read command Response:
AT+FPHCTO?
<tout>
OK/ERROR
Write command
AT+FPHCTO=<tout>
Response:
<tout>
OK/ERROR
Parameter:
<tout> 0...255
Time-out value in 100ms units.
Default: 30
Model-specific command to set bit order independently of the understanding
which is "mirrored" and which is direct
AT+FREV
AT+FREV Identify Product Revision
Used for FAX class 2 only
This command sends the revision identification to the TA.
Read command Response
AT+FREV?
V2.550
OK
AT+FRH
AT+FRH Receive Data Using HDLC Framing