Specifications

AT command set for XX Siemens mobile phones and modems
__________________________________________________________________________________________
Document No.: A30880-A10-A001-XX-
D376
Revision: Master R75
Revision Date: 29. September.2004
93
AT+GCAP
AT+GCAP Request Capabilities List
Test command Response:
AT+GCAP=? OK/ERROR
Read command Response:
AT+GCAP?
+GCAP: <mode
>
Parameter
<mode
> : e.g. “+GCAP: AT+CGSMS , AT+FCLASS”
AT+IPR
AT+IPR Fixed DTE rate
Test command Response:
AT+IPR=?
+IPR: (list of supported <rate
> values)
OK/ERROR/+CME ERROR
Parameter:
<rate
>
bits per second at which the DTE-DCE interface is to operate. The set
of supported values can be retrieved by means of the Test command.
0
Auto-bauding
Read command Response:
AT+IPR?
+IPR: <rate
>
OK/ERROR/+CME ERROR
Parameter:
<rate
>
See Test command
Write command: Response:
AT+IPR=<rate> +IPR: <rate>
OK/ERROR/+CME ERROR
Parameter:
<rate>
See Test command
2.9 Siemens defined commands
Since user-defined commands cannot be implemented according to official syntax, the character string ”+C” is
replaced by ”^S” (”^” = 0x5E). In future, if a user-defined command is accepted in the syntax prescribed in
3GPP TS recommendations, the command can be addressed using either command string.
AT^SABD
AT^SABD Accessory for Bluetooth Data
Test command
Response
:
AT^SABD=?
^SABD: (list of supported <mode
>s)
OK
Parameter:
<mode
>
See Write command
Read command Response:
AT^SABD?
^SABD: <mode
>
OK
Write command
AT^SABD=<mode>[,<data>]
Response:
[^SABD: <data>]
OK
Parameter: