Specifications

AT command set for XX Siemens mobile phones and modems
_________________________________________________________________________________________
_________________________________________________________________________________________
Document No.: A30880-A10-A001-XX-
D376
Revision: Master R75
Revision Date: 29. September, 2004
94
<mode>
integer type parameter, indicating the status of the
Accessory Data interface
0
disable Notifications and Accessory Data Transfer
1
enable Accessory Data Transfer Mode
2
Data Transfer mode
Note: It can be used directly since x65 devices, no
need to switch in mode 1 beforehand.
<data
>
String type, as input parameter only available in transfer
mode (see <mode> = 2),
Accessory specific data.
Unsolicited Result Code :
^SABD: <data>
Note:
Unsolicited Result Code, only available if write command with mode = 1 or 2 previously
entered, that is to say if Data Transfer Mode enabled.
AT^SACD
AT^SACD Accessory Data
Test command Response:
AT^SACD=?
^SACD: (list of supported <mode
>s)
OK/ERROR/+CME ERROR
Parameter:
<mode
>
See Write command
The Test command returns the modes for the Accessory Notifications and
Accessory Data Transfer
Read command: Response:
AT^SACD?
^SACD: (list of supported <mode
>s)
OK
The Read command returns the mode currently selected
Write command
AT^SACD==<mode>[,data]
Response:
[^SACD: <data>]
OK
Parameter:
<mode>
integer type parameter, indicating the status of the Accessory Data
interface
0
disable Notifications and Accessory Data Transfer
1
enable Accessory Data Transfer
2
Data Transfer mode
Note: It can be used directly as of x65 devices, no need to
switch in mode 1 beforehand.
<data
>
String type, as input parameter only available in transfer mode (see
<mode> = 2),
Accessory specific data.
The Write command enables the accessory notifications and accessory data
transfer. If the mode is set to ‘unsolicited Notifications’ , all accessory
notifications are issued with the unsolicited result code
Unsolicited Result Code for mode ‘2’:
^SACD: <data>