wassailing Lopsidedness s IS LIMITED LIFETIME WARRANTY Compass Manufacturing International warrants to the original consumer purchaser that the faucet be free from defects In material and workmanship for 2s long as the original consumer purchaser owns the home in which the faucet was first installed. In the event that Doreen faucets are used n a Commercial Application, this warranty s lifted for overload of 5 years, unless otherwise specifically stated In the catalog and/or price book.
Helpful Tools Tools: Gather the necessary tools as shown below to complete the installation of this faucet. Some may not be needed depending on the model of faucet you are installing. Check with your local hardware store on the requirements of your installation situation.
. Shut off water supply and drain lines. Clean sink surface thoroughly. Make sure mounting area is clean and dry. . Position spout {3 ,spout flange @) and O-ring@ on countertop. From underneath the counterclockwise clamp(® ,locknut(® and screw(9) ,and tighten with the screwdriver(But do not over connect the spout brass tee 83 to the spout by using the clip§3. .
. Position the shower holder §3 and secure it with washer @ and plastic lockout @ .Connect the pull-out hose @ to hand-held shower §3 . Caution: DON'T FORGET THE O-RING@ BETWEEN THE HAND-HELD SHOWER@ AND PULL-OUT HOSE §3. 5. Connect the connect hoses 43 and §2as shown and tight them with adjustable wrench. Assemble Hot and Cold faucet supply lines. CAUTION:DON'T OVER TIGHTEN THE SUPPLY LINES. OTHERWISE IT MIGHT DAMAGE THE WASHERS AND NUTS OF SUPPLY LINES AND CAUSE LEAK.