Installation Guide

A. B. C.
Warning:
The supply valves and
supply lines are not
included.
22
23
24
31
3
34
1
1. Position faucet on countertop.
2. From underneath the countertop, assemble clamp and locknut and
screw . Tighten the locknut by hand and secure the screws with the
screwdriver.
3. Connect pull-out hose to quick connect assembly .
CAUTION: Make sure hose is properly engaged and secure in quick connect
assembly.
4. Fix the weight to the pull-out hose .
5. Connect supply lines to water supply valve. (supply valves and supply lines
are not included).
CAUTION: DON'T OVER TIGHTEN THE SUPPLY LINES. OTHERWISE IT MAY DAMAGE
THE WASHERS AND NUTS OF THE SUPPLY LINES AND THIS COULD CAUSE THEM
TO LEAK.
6. Remove spray from faucet and flush water through faucet to remove
remove any debris.
7. Replace spray and run water through the faucet to check for leaks at
all of the connections.
22
23
24
3
31
34
3
1
es
Let both hot and cold water run for one minute. This will
help clean any debris that might clog the system.
5