Installation Guide

ManualsBrandsCMI ManualsKitchenPrestige Brushed Nickel 1-Handle Deck Mount High-Arc Handle/Lever Commercial/Residential Kitchen Faucet (Deck Plate Included)

Model No. : 191-7719 Polished Chrome

191-7720 Brushed Nickel

191-7721 Oil-Rubbed Bronze

Single Handle Pull-Out Kitchen Faucet

3 Hole or Single Hole Installation

Revised 4/28/16

In the event that Freendo faucets are used in a Commercial Application, this warranty is limited for

a period of 5 years, unless otherwise specifically stated in the catalog and/or price book.

Summary of content (4 pages)

PAGE 1
Model No. : 191-7719 191-7720 191-7721 Polished Chrome Brushed Nickel Oil-Rubbed Bronze In the event that Freendo faucets are used in a Commercial Application, this warranty is limited for a period of 5 years, unless otherwise specifically stated in the catalog and/or price book.
PAGE 2
8 Putty Plate 27 Deck Plate 26 25 Plastic Base Weight 24 Allen Key 23 Spray 22 Pull-out Hose Spout Hub Bushing 21 19 Hub Base O-ring 18 Shank 17 16 Protective Sleeve Clamp 15 Locknut 14 Screw Quick Connect Assembly 20 13 11 Waterway Sleeve O-ring 10 Waterway 9 Cartridge 8 Cartridge Adapter 7 Cartridge Locknut 6 Body 5 4 Washer Trim Cap 3 Handle 2 Index 1 Set Screw No.
PAGE 3
Install With Deck Plate 1 3 23 2 23 4 5 6 22 21 27 28 7 5 8 20 9 13 26 24 19 16 15 14 10 22 25 18 17 25 16 15 14 26 11 13 12 27 28 1. Assemble deck plate 27 and putty plate 28 to faucet. 2. Position faucet on countertop. 3. From underneath of the countertop,assemble plastic base 26 (NOTE: applicable when the faucet is installed in sink), clamp 16 and locknut 15 and screw 14 .Tighten the locknut by hand and secure the screws with screwdriver. 4.
PAGE 4
Install Without Deck Plate 23 A. B. C. Warning: The supply valves and supply lines are not included. 26 16 15 14 13 22 25 1. Position faucet on countertop. 2. From underneath of the countertop,assemble plastic base 26 (NOTE: applicable when the faucet is installed in sink), clamp 16 and locknut 15 and screw 14 .Tighten the locknut by hand and secure the screws with screwdriver. 3. Fix the weight 25 to the pull-out hose 22 . 4. Connect pull-out hose 22 to quick connect assembly 13 .