Installation Guide

A. B. C.

Remove the spray head and let both hot and cold water run

for one minute. To clear any line trash. This will help clean

any debris that might clog the system. Re-assemble spray

head.

Important:

Warning:

The supply valves and

supply lines are not

included.

Install Without Deck Plate

1. Position faucet on countertop.

2. From underneath of the countertop,assemble plastic base (NOTE:

applicable when the faucet is installed in sink), clamp and locknut and

screw .Tighten the locknut by hand and secure the screws with screwdriver.

3. Fix the weight to the pull-out hose .

4. Connect pull-out hose to quick connect assembly .

CAUTION:Make sure hose is properly engaged and secure in quick connect

assembly.

5. Connect supply lines to water supply valve.(supply valves and supply lines

are not included,please purchase them in local plumbing shops).

CAUTION: DON'T OVER TIGHTEN THE SUPPLY LINES.OTHERWISE IT MIGHT DAMAGE

THE WASHERS AND NUTS OF SUPPLY LINES AND CAUSE LEAK.

6. Remove spray from faucet and flush water through faucet to remove

any line trash.

7. Replace spray and run water through faucet for checking leaks at all

connections.