Installation Guide

ManualsBrandsCMI ManualsBathroomCardania Polished Chrome 2-Handle 4-in Centerset Bathroom Sink Faucet with Drain

Model No. : 192-6401 Polished Chrome

192-6402 Brushed Nickel

192-6403 Oil-Rubbed Bronze

Cardania Two Handle Bathroom Faucet

With Pop-up

3 Hole Installation, 4 Center-Set

Revised 4/24/17

In the event that Freendo faucets are used in a Commercial Application, this warranty is limited for

a period of 5 years, unless otherwise specifically stated in the catalog and/or price book.

repair. Compass Manufacturing International will, at its discretion, provide new or equivalent replacement

parts for any product that proves to be defective under normal usage and service.

Summary of content (4 pages)

PAGE 1
Model No. : 192-6401 192-6402 192-6403 Polished Chrome Brushed Nickel Oil-Rubbed Bronze In the event that Freendo faucets are used in a Commercial Application, this warranty is limited for a period of 5 years, unless otherwise specifically stated in the catalog and/or price book. repair. Compass Manufacturing International will, at its discretion, provide new or equivalent replacement parts for any product that proves to be defective under normal usage and service.
PAGE 2
4 1 3 2 3 5 6 7 8 9 11 10 12 13 35 15 14 16 35 Faucet Tailpiece 34 Lift Rod 33 32 Extend Rod Spring Clip 31 Rod Guide Nut 30 Rod Ball Plastic Gasket 29 28 Horizontal Rod Tailpiece 27 Drain Body 26 Locknut 25 Washer 24 23 Bottom Rubber Washer Top Rubber Washer 22 Flange 21 Drain Stopper 20 Extend Rod Screw 19 Allen Key 18 Aerator Wrench Handle of lift rod 18 17 19 16 15 13 Screw Brazed Underbody 12 O-ring 11 Cartridge(Cold Water) 10 Cartridge(Hot Water) 14 17
PAGE 3
A . Faucet tailpiece B . Faucet tailpiece C . Faucet tailpiece 15 16 1 2. Remove the plastic locknut 16 from faucet. Don't remove the putty plate 15 from faucet. 15 Warning: The supply valve and supply lines are not included. 35 16 This will help clean any debris that might clog the system. Re-assemble aerator. 3. Position the faucet on the countertop with putty plate 15 . Replace the plastic locknuts 16 on the faucet tailpiece 35 and tighten the plastic locknuts 16 by hand.
PAGE 4
flange 22 handle of lift rod 17 top rubber washer 23 drain body 27 flange 22 sink base drain stopper 21 o-ring faucet body sink horizontal rod 29 washer 25 locknut 26 tailpiece 28 bottom rubber washer 24 align hole in drain stopper with guide rod opening (pointed toward back wall) drain body 27 A. Remove pop-up drain stopper 21 . A. Replace pop-up drain stopper 21 and flange 22 with top rubber to drain body 27 with o-ring in washer 23 for pop-up assembly. place, and align stopper hole B.