Compass @ Manufacturer ATONAL Overspends fondants LIMITED LIFETIME WARRANTY Compass Manufacturing International warrants to the original consumer purchaser that the faucet be free from defects In material and workmanship for 2s long as the original consumer purchaser owns the home in which the faucet was first installed. In the event that Doreen faucets are used n a Commercial Application, this warranty s lifted for overload of 5 years, unless otherwise specifically stated In the catalog and/or price book.
Helpful Tools Tools: Gather the necessary tools as shown below to complete the installation of this faucet. Some may not be needed depending on the model of faucet you are installing.
. Install the cartridge @, cartridge sleeve @ and trim cap@ into the valve body. 4. Close bathtub drain to avoid losing parts. Install escutcheon@and secure it with escutcheon screws and escutcheon screw o-rings 49). Make sure valve is in off position. Then assemble the handle(7) and secure it with set screw 5. Apply Teflon tape to two ends of shower arm@ and install it to wall with shower arm range@ . And connect the shower head (3) to shower arm(2).
1. Connect pipes with faucet as shown, pay attention to the connection of hot and cold water supply pipe. 2. For tub spout installation only: install for spout,use proper length so that the pipe will extend from the finish wall. In order to assure proper function, piping from the bottom port of valve to tub spout outlet must be either 1/2" nominal copper pipe or 1/2" iron pipe. 3.Turn on hot and cold water supply lines and flush the debris in the lines.