Compass @ Manufacturer ATONAL Overspends fondants LIMITED LIFETIME WARRANTY Compass Manufacturing International warrants to the original consumer purchaser that the faucet be free from defects In material and workmanship for 2s long as the original consumer purchaser owns the home in which the faucet was first installed.
Helpful Tools Tools: Gather the necessary tools as shown below to complete the installation of this faucet. Some may not be needed depending on the model of faucet you are installing. Plumber's Putty Basin Wrench Safety Glasses and/or Silicons Adjustable Wrench Flashlight Screwdriver Pullers Channel Locks Maintenance Your new faucet is designed for years of trouble-free performance. Keep It looking new by cleaning It periodically with a soft, damp sloth.
.| Part Name Handle O-ring O-ring Set Screw Handle Base Handle Connector, Sower Knob Knob Conn actor Spout Set Screw O-sing Stopper Aerator Allen Wrench Allen Wrench Lock Nut O-ring Washer Clamp Lock Nut Sowers Set Resew Handle Adapter Cartridge (Hot) Brass Valve Body Cap O-ring Spout Lock Nut O-ring C A.% B Warning: ? The supply valves and |on|efo|n | 5 supply lines are not included. N oSS [ Connect to water supply lines with either: 0.D.
1. Shut off the water supplies and drain the lines. Clean and dry the mounting surface thoroughly. 2. Remove the spout lock nut (#29) and cap (#27) from the brass waterway Ensure the lock nut (#21) is far enough down on the brass waterway (#31) to fit your mounting surface. From underneath the mounting surface, insert the brass waterway (#31) into the second hole from the left. From above, reinstall the spout lock nut Tighten the lock nut (#21) hand tight.