Installation Guide

ManualsBrandsCMI ManualsKitchen SinksCompass 33-in x 21-in Stainless Steel Double Equal Bowl Tall (8-in or Larger) Undermount Apron Front/Farmhouse Residential Kitchen Sink with Drainboard

Table Of Contents

— —

Please follow all local plumbing and building codes.

The warranty will be voided if these installation instructions are not followed.

Inspect the drain and supply lines; replace if necessary.

CAUTION: Risk of personal injury. Metal surfaces are sharp and cause severe cuts.

Please use gloves and handle sink with care.

BEFORE INSTALLING THE SINK, INSPECT IT FOR DAMAGE. DO NOT INSTALL

A DAMAGED UNIT.

Disclaimer: This application must use a modified sink base and solid

surface countertop material.

FOR EXPERIENCED AND PROFESSIONAL INSTALLATION ONLY

Step 4

Locate and drill the mounting holes (following the countertop manufacturer’s

instructions). Holes should allow even spacing of mounting brackets around the sink.

Please use the fasteners recommended by the countertop manufacturer.

Step 5

Fasten the mounting brackets to countertop loosely.

Step 7

Position and align the sink over the countertop opening. Press silicone onto countertop.

Step 6

Using a good quality silicone sealant, apply a bead evenly all around the top of the sink

flanges.

Step 1

Position the template on countertop. Locate the template front to rear, so that the sink

does not interfere with the cabinet.

Step 3 (Attach the Undermount Clips)

Position bowl so that reveal is equidistant.

Then on underside of countertop, drill holes

for brass inserts of undermount clips.

Use a drill bit with stop block to avoid driling

through the top. For 1/2'' countertop material,

drill 3/8'' deep holes. Use three clips on the long

sides of the sink, and two clips on the short of the

sink, or follow the locations on the template that

comes with the sink. Drill the holes 1'' back from

the cut-out edge.

Step 3

NOTE :

The clip may be too long for some installations. If this is the case, make a brace

out of wood or solid material, butt it up against the sink, and on site, screw it into

the cabinet wall. Measure the thickness of the brace and the cabinet wall so the screw

does not go though to the other side of the cabinet.

Step 2

Trace a line around the template. Cut along the inside of this line to create the opening.

The opening will provide a 1/8" overhang of the countertop.

Under-Mount Apron Front Farm Sink Installation Instructions

Summary of content (2 pages)

PAGE 1
Under-Mount Apron Front Farm Sink Installation Instructions Step 1 FOR EXPERIENCED AND PROFESSIONAL INSTALLATION ONLY Disclaimer: This application must use a modified sink base and solid surface countertop material. Position the template on countertop. Locate the template front to rear, so that the sink does not interfere with the cabinet. BEFORE INSTALLING THE SINK, INSPECT IT FOR DAMAGE. DO NOT INSTALL A DAMAGED UNIT. CAUTION: Risk of personal injury. Metal surfaces are sharp and cause severe cuts.
PAGE 2
LIMITED LIFETIME WARRANTY Step 8 Tighten fasteners until the mounting brackets are snug against the sink. Countertop Sink Fasteners Step 9 Screws Check alignment of sink countertop opening. Step 8 Step 10 Tighten down the fasteners evenly. Be careful not to overtighten. Remove excess silicone.