User's Guide

Table Of Contents

5. Put the device onto the installed plate, slide it downward, and attach them with the screw

(M3 x 6)

2.2.2. Mounting Device (Gang Box Mount)

You can also install the device on a gang box (outlet box) by using the mounting plate.

1. Remove the screw that attaches NovaFace to the mounting plate and disassemble them.

Keep the screw because it will be used to attach them again.

2. Put the mounting plate onto the gang box and attach it to the box with the screws (M4 x 8).

Gang box mounting points

Make sure that the outgoing cables from the gang box go through the

rectangular opening in the plate.

3. Connect the power cable and peripherals cables, if necessary, to the connectors in the rear

panel. (See OOO for more information)

4. Put the device onto the installed plate, slide it downward, and assemble them with the

screw (M3 x 6)

NovaFace User Guide, 0.1

May 2020

Page

14 of 28