Installation Manual

ManualsBrandsCmple ManualsAccessories & SuppliesUniversal Adjustable Ceiling Projector Mount, 360 Degree Swivel Rotatable Projector Bracket - Max 22lbs (Silver)

Table Of Contents

INSTALLATION MANUAL

CAUTION: DO NOT EXCEED RATED

LISTED WEIGHT CAPACITY. SERIOUS

INJURY OR PROPERTY DAMAGE MAY

OCCUR!

Projector Ceiling Mount

10kg

(22lbs)

RATED

10kg

(22lbs)

RATED

Maintenance

• Check that the bracket is secure and safe to use at regular intervals(at least every three months).

• Please contact your dealer if you have any questions.

1070-N

Summary of content (6 pages)

PAGE 1
INSTALLATION MANUAL Projector Ceiling Mount Maintenance • Check that the bracket is secure and safe to use at regular intervals(at least every three months). • Please contact your dealer if you have any questions. 1070-N 11 10kg (22lbs) RATED CAUTION: DO NOT EXCEED RATED LISTED WEIGHT CAPACITY.
PAGE 2
NOTE: Read the entire instruction manual before you start installation and assembly. Component Checklist IMPORTANT: Ensure that you have received all parts according to the component checklist prior to installation. If any parts are missing or faulty, telephone your local distributor for a replacement. WARNING • Do not begin the installation until you have read and understood the instructions and warnings contained in this installation sheet.
PAGE 3
1b. Solid Brick and Concrete Mounting 1a. Wood Ceiling Mounting 55mm ((2.2") (2.2”) 2.2”) 55mm 50mm ((2") (2.2") 2.2") ø 10mm (ø 3/8") ø 4.
PAGE 4
3. Attaching the Mounting Legs and the Projector Plate 2. Installing the Decorative Cover and the Extension Pipe 3a.common mounting M-B E or F M-B M-H Run the projector cables through the pipe. or Press in the two bolts at the same time and connect extension pipe to ceiling plate. or M-B M-H M-H M-D Turn bolt outside for maximum safety. Locate the projector’s mounting points. Screw the mounting legs onto the projector. DO NOT TIGHTEN ALL SCREWS AT THIS TIME.
PAGE 5
3b. for Toshiba projectors 3b-1. For Toshiba projectors M-C M-F W-C M-D Attach the adjustable part to the projector using the screws. M-G M-A M-B M-H M-H Locate the projector’s mounting points. Screw the mounting legs onto the projector. Place the projector plate on the mounting legs, as close as to projector center of gravity as possible. Slightly adjust the arms to fit slots pattern on the projector plate. And then use screws and washers to fix the projector plate.
PAGE 6
4. Hang the Projector onto the Ceiling Mount 3b-2. for Philips projectors M-E Insert adjustable part into projector. M-B M-H M-H M-D Locate the projector’s mounting points. Screw the mounting legs onto the projector. Turn bolt outside for maximum safety. DO NOT TIGHTEN ALL SCREWS AT THIS TIME. Press in the two bolts at the same time and connect projector plate to pipe. Important: Make sure the projector is correctly hooked before releasing the projector. 5.