User guide

CMT User Guide

2. Click on the New DVR Button

3. Enter the Name and IP Address

Important:

Do not use the Tab Key when entering the IP Address - instead use the full point key (.)

to seperate segments.

--OR--

4. Enter the Name and Fully Qualied Domain Name of the DVR by clicking on the

FQDN Button

5. Enter the System Login and Password information. The default values are listed

below:

Figure 5 DVRs Tab - System Credentials

6. Press the Save DVR Button to save this DVR to the CMT database.

7. If the following message is displayed, check the IP address and the web port

number and verify the unit is online.

8. If the following message is displayed, refer to the Trouble Shooting section at the

back of this manual (Remove Credentials button).

9. The Unit Information will be displayed on the lower left hand section of the screen,

the Name and IP will also be added to the list at the top of the screen. Two

messages will be displayed: one advising that a New DVR is being added to CMT

and the second indicating that the conguration of this DVR is being backed-up

(this C/R point will appear on the Copy Restore Tab).

Important: This DVR will be locked until the backup is complete.