VER1120087720 DESIGN MINI SYSTEM DMS 7720 USER MANUAL -1-
General Imprint All rights reserved. Any reproduction without consent of cmx® is prohibited. cmx® reserves the right to modifications of the device.
General CONTEXTS 1. GENERAL ...................................................................................... - 1 1.1. Safety Precautions ................................................................ - 1 1.2. Disposal of Waste Electronic Equipment .............................. - 2 1.3. Battery Disposal .................................................................... - 2 1.4. Copyright ............................................................................... - 2 1.5. Hearing Protection ..
General 9.3. SD and MMC memory card reader ..................................... - 18 9.4. AUX ..................................................................................... - 18 10.FURTHER OPERATION .................................................................. - 19 11.TROUBLESHOOTING ..................................................................... - 20 12.WARRANTY ................................................................................. - 22 12.1. Warranty Procedure ..............
General 1. General 1.1. Safety Precautions Only connect to mains power supply (230 Volt/50 Hz). Do not place containers filled with water on top of the device. Do not place the device in close proximity of water (e.g. sink, wash basin, etc.). The device can fall into the water and cause a short circuit. The device consumes some power during standby operation. For zero power consumption disconnect from mains power supply.
General 1.2. Disposal of Waste Electronic Equipment Your product is manufactured from high quality raw materials and should be recycled. Ask your municipality for collecting points for waste electronic equipment. Do not dispose of old appliances with the household waste. The symbol on the product, the instructions for use or the packing will advert about the methods for disposal. 1.3. Battery Disposal The law requires returning exhausted batteries to public collection points or the dealer.
General Only turn the volume to a level where you can still hear ambient noise. 1.6. Cleaning and Maintenance Cleaning the Casing Clean the casing with a dry cloth. Before cleaning disconnect from mains power supply. Do not clean with liquid cleaning agents or a wet cloth; this can cause a short circuit. Cleaning CDs Clean CDs with a soft cloth from the center to the edge. Do not use solvents or abrasive cleaning agents. Do not use pointed or sharp utensils for cleaning; this will damage the CD.
Features 2. Features This HiFi system – DMS 7720 can play all Audio CDs and MP3 CDs. Music playback is also possible via USB port and SD card reader. You may also play your MP3 files directly from the MP3 player connected to AUX in. Purchase the AUX cable separately.
Location of controls 3. Location of controls 3.1. Main unit - front 1 LCD display 2 FM.ST Stereo/Mono 3 STANDBY LED Status indicator 4 XII / CD: start and pause playback USB: select playback from MP3 player / USB-Stick 5 STOP/SD CD: Stop playback SD: select playback from SD card 6 -10/FOL-“ -10: Skip 10 tracks back FOL-: skip to previous folder 7 CD: rewind / previous track 8 VOL- UND VOL+” Increase volume Decrease volume 9 AM/FM/FM.ST Toggle between AM/FM/FM.
Location of controls 10 PHONES Earphones/headphones jack 11 AUX Port for MP3 player / USB stick 12 BASS LED Status indicator 13 BASS On/off switch bass 14 Infrared sensor For remote control 15 POWER On/off switch 16 PROG. programming 17 REP./RAN.
Location of controls 3.2.
Location of controls 3.3.
Preparation 4. Preparation 4.1. Connections Follow these steps to connect the system: Schritt 1 LR L R Schritt 2 1. Connect the speaker cables to the speaker jacks. 2. Connect to mains power supply. The system is in standby mode and the status indicator lights up red. Disconnect the system from mains power supply during extended periods of non-use; it consumes a certain amount of power in standby mode. Further information regarding connections see in chapter 10.
Preparation 4.2. Insert battery The battery compartment is at the top of the remote control. 1. Insert two AAA batteries (1,5V LR03) observing the polarity (+ and -) as marked inside the battery. Notes: Batteries not included - 2 pieces AAA (1,5V LR03) for remote control necessary! The lifetime of the battery is approximately 6 months with normal use. To avoid damage remove the battery from the remote control during extended periods of non-use.
CD player 5. CD player 5.1. Insert CD / MP3-CD 1. Press OPEN/CLOSE to open the CD door horizontally. 2. Insert a CD with the label up and carefully press it down onto the ball bearing spindle. 3. Press the OPEN/CLOSE button to close the CD drive. Do not close the CD drive manually; this can cause damage to the mechanism. 5.2. CD / MP3 CD Playback This system can play CDs / MP3 CDs in different playback modes. 1. Press the PLAY/MODE button on the remote control to select the desired mode.
CD player 5.3. Program CD/ MP3 tracks You can program your own playlist with up to 99 tracks. 1. During CD / MP3 CD playback press the STOP button before programming. 2. Press the PROGRAM button on the remote control or PROG. on the system until P01 and „Program“ is displayed. 3. Press or on the remote control until the desired track is displayed. 4. Press the PROGRAM button on the remote control or PROG. on the system. 5. Repeat steps 3 and 4 to program further tracks.
Cassette deck 6. Cassette deck 6.1. Insert cassette 1. Bellow the cassette deck you find the „OPEN“ button for cassette playback. 2. Press the STOP/OPEN button to open the cassette compartment. 3. Insert the cassette with the recorded side to the front. 6.2. Cassette playback 1. Insert a cassette as described under point 6.1. 2. Press the PLAY button to start cassette playback. Turn the cassette around in case, the „PLAY“ button does not lock in place. 6.3.
Cassette deck 1. Connect or insert your music source. 2. Insert a cassette into the cassette compartment. 3. Simultaneously press the RECORD and PLAY buttons to record to cassette. The audio cassette has two sides. Please insert the cassette the correct way. The cassette must be rewound. In recording mode playback of other sources is not possible. 6.4. Further Operation Setting playback Stop playback Press STOP. Pause Press PLAY/PAUSE. Press again to continue playback. Fast forward Press .
Radio 7. Radio 7.1. Listen to radio 1. Press the FUNCTION button until „RADIO“ is displayed. 2. Select AM / FM or FM stereo. 3. Turn the tuning knob to tune into your favorite radio station. For best reception point the antenna in a different direction or choose a different location.
Sound Scenarios 8. Sound Scenarios 8.1. Bass You can boost the bass for a more dynamic sound. 1. Press the BASS button on the unit. “BASS” is displayed.
External Components 9. External Components 9.1. Connect Earphones 1. Connect your earphones or headphones. The speakers are muted if earphones are connected. To avoid hearing problems do not use earphones or headphones for an extended period of time. Increased sound pressure from earphones or headphones can cause hearing loss. See chapter 10 for further settings. 9.2. USB 2.0 Extend your system by connecting your MP3 player or USB stick. Do not disconnect the device when “USB” mode is selected. 1.
External Components 9.3. SD and MMC memory card reader Extend your system by inserting an SD or MMC memory card in the card reader. 1. Insert the SD or MMC card in the card reader. 2. Switch to „MP3“ mode on the unit. 3. Press and hold the STOP/SD button. 4. To avoid damage only disconnect after pressing STOP and selecting a different mode. See chapter 10 for further settings. 9.4.
Further Operation 10. Further Operation This operation you have for CD playback and for external components (SD / MMC / USB). Procedure Operation Stop playback Press the STOP/SD button. Pause Press XII/USB. Press again to resume playback Skip mode Press or during playback or pause modes. Skip to next folder Press the -10FOL- or +10/FOL+ button. Skip 10 tracks ahead Skip 10 tracks back Press the +10 button. Press the -10 button.
Troubleshooting 11. Troubleshooting Contact the service hotline or use the contact form on the homepage in case of problems with the system that are not dealt with here. Malfunction Solution “No disc” Insert a CD. Insert a finalized CD-RW or CD-R. Insert the CD with the label up. Try another CD or clean the CD. Increase the distance to TV set or Bad reception DVD player. Point the antenna in a different direction.
Troubleshooting connected. Remote control Increase the volume. Disconnect the earphones. Deactivate MUTE mode. Decrease the distance to the system. does not work. Exchange the battery. Point the remote control towards the system’s IR sensor. No CD playback. Check your CD for damages or scratches. USB stick / SD memory card does Insert the CD with the label up. Use a different USB stick or SD card to check the function.
Warranty 12. Warranty This system comes with a 24-month warranty from the date of purchase. Please keep your purchase documents! In case of manufacturing or material defects the warranty consists of rectification of defects or exchange. The warranty does not include damages or malfunctions due to improper use wear and tear repairs by third parties The warranty does not include display damage firmware update accidental damage. Repair does not extend the warranty period. 12.1.
Warranty Service hotline o Austria: +43 0720 502671 – please dial with the zero! o Germany: +49 (0)180 166 66 264 621 o Switzerland: +41 (0) 848 00 3322 Contact form – www.cmx-electronics.com 12.2. Warranty has expired Please contact us by phone or contact form in case your warranty has expired. We will help you! Please inform us about the following: Unit type Purchase date Malfunction 12.3.
Warranty Attach filled-out warranty card Error description Example for error description Wrong Correct Unit is defective Unit does not respond Unit malfunctions Unit cannot be switched on Sender information: Name, address, ZIP code, city and phone number and e-mail address - 24 -
In the box 13. In the box Please contact your dealer directly in case one of the accessories is missing or damaged.
Technical specifications 14. Technical specifications CD-Player Formats Audio CD / Audio CD-R / Audio CD-RW MP3 CD / MP3 CD-R / MP3 CD-RW Frequency range 100 Hz ~ 16 kHz S/N ratio 30 - 35 dB Radio Frequency bandes AM / FM & FM Stereo frequencies AM FM 522 – 1620 kHz 87,5 – 108 MHz Connectors Inputs USB 2.0 Outputs 3,5 mm headphones Speakers (left / right) Card reader SD cards MMC cards Speakers Power output Max.
Technical specifications General Power consumption 17 Watt Mains power AC 230 V ~ 50 Hz dimensions 469 x 229 x 218 mm - 27 -
Technical specifications www.cmx-electronics.