User`s manual

ThinkCore IA241/240 Linux User’s Manual Getting Started

2-2

Powering on the IA241/240

Connect the SG wire to the shielded contact located in the upper left corner of the IA241/240, and

then power on the computer by connecting it to the power adaptor. It takes about 30 to 60 seconds

for the system to boot up. Once the system is ready, the Ready LED will light up.

NOTE After connecting the IA241/240 to the power supply, it will take about 30 to 60 seconds for the

operating system to boot up. The green Ready LED will not turn on until the operating system is

ready.

ATTENTION

This product is intended to be supplied by a Listed Power Unit and output marked with “LPS”

and rated 12-48 VDC, 580 mA (minimum requirements).

Connecting the IA241/240 to a PC

There are two ways to connect the IA241/240 to a PC: through the Serial Console port or via

Telnet over the network.

Serial Console

The serial console port gives users a convenient way of connecting to the IA241/240’s console

utility. This method is particularly useful when using the computer for the first time. The signal is

transmitted over a direct serial connection, so you do not need to know either of its two IP

addresses in order to connect to the serial console utility.

Use the serial console port settings shown below.

Baudrate

115200 bps

Parity

None

Data bits

Stop bits:

Flow Control

None

Terminal

VT100