User`s manual

ThinkCore IA241/240 Linux User’s Manual Getting Started

2-3

Once the connection is established, the following window will open.

To log in, type the Login name and password as requested. The default values are both root:

Password: root

Telnet Console

If you know at least one of the two IP addresses and netmasks, then you can use Telnet to connect

to the IA241/240’s console utility. The default IP address and Netmask for each of the two ports

are given below:

Default IP Address Netmask

LAN 1

192.168.3.127 255.255.255.0

LAN 2

192.168.4.127 255.255.255.0

Use a cross-over Ethernet cable to connect directly from your PC to the IA241/240. You should

first modify your PC’s IP address and netmask so that your PC is on the same subnet as one of

IA241/240’s two LAN ports. For example, if you connect to LAN 1, you can set your PC’s IP

address to 192.168.3.126 and netmask to 255.255.255.0. If you connect to LAN 2, you can set

your PC’s IP address to 192.168.4.126 and netmask to 255.255.255.0.

To connect to a hub or switch connected to your local LAN, use a straight-through Ethernet cable.

The default IP addresses and netmasks are shown above. To login, type the Login name and

password as requested. The default values are both root:

Password: root