User Guide

INSTRUCTIONS FOR COAST FL70 HEADLAMP:
BAT TERY INSTALLATION:
The FL70 uses three A AA alkaline batteries located in the rear of the
headlamp. To access the battery compartment, hinge the headlamp
downward to reveal the rear of the headlamp body. Once the rear of
the headlamp is revealed, pull the locking mechanism up to unlock the
battery compartment. Insert the batteries in the direction indicated in-
side the headlamp, close the battery compartment door until it ‘clicks’
shut, and hinge the headlamp back towards the reflective strap. Never
mix old and new batteries. Remove batteries before storing headlamp
for extended periods of non-use.
Note: The FL70 in clam packaging comes with batteries pre-installed.
LIGHT OPERATION:
To turn on the white light, depress the power switch on the top-right
side of the headlamp while worn to enter “High” mode. Depressing
the same button a second time soon after will switch the headlamp to
“Medium” mode. A third depression of the button soon after will turn
the headlamp into “Low” mode. To shut down the light, depress the
power switch a fourth and final time, or sometime after the previous
depression.
FOCUS AND BEAM POSITION ADJUSTMENT:
This headlamp is equipped with COAST’s Pure Beam Focusing Optic
System with Twist Focus, which allows the user to choose between a
broad flood beam and a focused Bulls-Eye Spot beam for long distance
illumination. To adjust the beam into flood light mode, rotate the Twist
Focus Ring bezel around the lens of the light counterclockwise when
wearing the headlamp. To adjust the beam into Bulls-Eye Spot mode,
rotate the Twist Focus Ring bezel around the lens of the light clockwise
when wearing the headlamp.
The hinged adjustment allows you to tilt the headlamp downward to
illuminate close objects. To adjust the tilt position of the headlamp, hold
the body of the headlamp with one hand and tilt the body away from
the back plate (which retains the strap), holding the back plate with a
second hand (if necessary).
HEAD STRAP ADJUSTMENT:
To adjust the FL70 to fit your head, slide the buckles on the side of
the head strap. It may be necessary to reposition the headlamp and
battery pack on the side head strap once the headband is adjusted to
the proper size.
HARD HAT SAFETY HELMET CLIP USE:
The FL70 includes helmet clips for use with hard hat style safety
helmets. To use the helmet clips, loosen the side of the strap to fit
the helmet and attach the clips to the side strap of the headlamp,
evenly spaced with two on each side. Attach the headlamp to the safety
helmet and attach the clips to the rim of the helmet. Some adjustment
of the clip positions and head straps will be necessary for proper fit
on safety helmets.
NOTE: Clips are designed for use ONLY with HARD HAT style safety
helmets.
MAINTENANCE:
Wipe the external body with a cloth moistened with water or isopropyl
alcohol. Allow alcohol to dry before use. Do not submerge.
FL70
16-801v01N 1608A
For warranty and distributor information in
your country, visit: www.COASTportland.com