Manualshelf

Instructions / Assembly

ManualsBrandsCoastal Shower Doors ManualsAlcove Shower DoorsNewport Series 44 in. x 70 in. Framed Sliding Shower Door with Towel Bar in Chrome and Clear Glass
1234
Table Of Contents
3
NEW PORT 08-26-08
With high lip toward exterior of enclosure, position Sill at center of
shower curb. Temporarily tape Sill to shower curb to prevent move-
ment.
Place Wall Jambs (C) on to ends of Sill (B) and up against shower
walls as shown in figure 3. Push the notched Wall Jambs down over
the Sill, making sure the Jamb is securely seated onto the Sill. Plumb
the Jambs, then pencil mark their installation hole locations on the
shower walls (3 per jamb). Remove Wall Jambs. Using a 3/16”
glass / tile drill bit, drill 1” deep installation holes in locations previ-
ously marked. Insert Plastic Screw Anchors (M) into holes.
BEFORE STARTING
Before starting unit installation, Please check the box contents
against the parts list. Make sure all material is accounted for.
Measure the base opening along center of shower curb as shown
in figure 1, then trim Sill (B) to measurement obtained.
Measure the wall to wall opening at the top of the Wall Jambs
(C) and cut the Header (A) to 1/16" less than the measurement
obtained. Position Header (A) on top of the Wall Jambs (C) and
leave it there as we make preparations for panel installation.
STEP 5 Measure Header opening & cut Header
STEP 1 Measure base opening & cut Sill
pg , g
Trim the Vinyl Seal (X) to an inch and one eighth (1-1/8”) less than
the base opening. Slide Vinyl Seal into the Sill’s receiver as shown
in figure 2 and center it on the Sill.
STEP 2 Trim Insert Vinyl Seal into Sill
STEP 3 Positon Sill and Wall Jambs
STEP 4 Secure Wall Jambs
Reposition Wall Jambs as before and secure to shower walls
using five (5) #8 x 1-1/2" Installation Screws (L), see exploded
view - sheet 1.
Insure that both Jamb Bumpers (N) and Bumper Washers (U)
are secured to the Wall Jambs (C) using the center installation
screw, see figure above and exploded view - sheet 1.
Use the #8 x 2" Flat Head Screw (T) to secure Jamb Guide (R)
to the lower installation hole of the Wall Jamb that is attached to
the shower head wall.
Using the exploded view as a guide, attach Rollers (I) to Hanger
Brackets (S) using an #832 hex head screw (J). Note: protrud-
ing hex head on roller should always face hanger bracket.
STEP 6 Roller installation