Installation Guide

4
STEP 9 Towel Bar Installation
STEP 10 Leak Proof Installation
To insure a leak proof installation . . . Run a bead of clear
mildew resistant caulking down the full length of each Wall
Jamb, outside where the Wall Jambs meet the walls. Now run
a bead inside where the Wall Jamb straddles the Sill. Follow
caulking manufacturer's instructions before using shower.
Installation is now complete.
STEP 7 Door Panel Installation
Take what will be the inside Panel and stand it inside the shower
enclosure (make sure the Rollers (I) are facing toward the inside
of the enclosure as shown in exploded view - sheet 1). Leave it
there temporarily.
Install the outside Door Panel (D) by Lifting the Panel up and
into the Header (A). Lower the Panel and engage the Rollers (I)
with the roller track.
Slide
outside Door Panel into Wall Jamb located on wall
opposite of shower head.
Check Panel to make sure that it is parallel to the Wall Jamb. If
it is not, remove the Door Panel and adjust the rollers either up
or down by loosening the Roller Screws and sliding the Rollers.
When satisfied with outside Door Panel alignment, proceed with
inside Door Panel installation.
When installed, slide the inside Door Panel into the Wall Jamb
located on shower head wall and check for alignment with Wall
Start by sliding a Sleeve (F) . . . flat end first . . . over each of the
four Towel Bar Brackets (G) as shown in figure above.
If not already closed, close Door Panels (inside Panel against
shower head wall and outside Panel against opposite wall).
As shown in figures 9A & 9b below, begin by installing inner
Brackets first and securing Brackets with a #832 x 1-1/4 Towel
Bar Screw (K).
Now finish the Towel Bar installation for each Door Panel as
shown in exploded view - sheet 1 and secure each Bracket with a
#832 x 1-1/4 Towel Bar Screw (K). Do not forget the Finger Pulls
(E). Use figures below as guides.
Finish Towel Bar installation by pealing the back off the metallic
CI logo (V) and installing it over the screw head on the Finger
Pulls (E).
FIGURE 9A
(SHOWER HEAD ON LEFT)
FIGURE 9B
(SHOWER HEAD ON RIGHT)
STEP 8 Screw on Track Guide
To insure proper operation, Track Guide (P) must be centered on
Sill (B) when installed.
Open the shower door enclosure so that both Door Panels are up
against the same Wall Jamb.
Locate the center of Sill and position the Track Guide on the Sill,
making sure that the Door Panels are riding in their respective
tracks.
Using the holes on Track Guide as templates, secure Guide to
the Sill using two 638phpt Self Drilling Screws (W) as shown in
figure above.
When finished, closed Door Panels as before (inside panel
toward shower head wall, outside panel against opposite wall).