Installation & Assembly

“ILLUSION” FRAMELESS SHOWER ENCLOSURE

INSTALLATION INSTRUCTIONS

Need some help? Call our customer service team at 1-800-874-8601

C 956 C

98-45

C 956 C

4. Next, measure from the bottom of the Vinyl Strike Post (C 180 C)

to the bottom of the Door Strike (931 M). This will determine where

your magnet will meet the Door Strike.

5. Trim the Seal Vinyl (C 956 C) 1/2” longer than your measurement,

to account for the extra room at the bottom Sill (CST 900S). Then,

slide the Seal Vinyl (C 956 C) inside the Vinyl Strike Post (C 180 C)

with the wing facing outward.

C 956 C

Trim Here

STEP 8. INSERT DOOR/STRIKE POST VINYL AND MAGNET

1. On the edge of the door glass, center the Door-

Strike Vinyl (C 955 B) between the holes you’ll

later use for installing the handle.

2. Place the Door Strike (931 M) over the Door-Strike

Vinyl (C 955 B), with the thicker edge toward the

inside of the shower. (This edge will work with

your magnet.) Tap the Door Strike into place with

a rubber mallet.

3. Use a box cutter to carefully trim any excess vinyl from around

the Door Strike (931 M).

C 955 B

931 M

6. Slide the Magnet (98-45) inside the Vinyl Strike Post (C 180 C) to

rest on top of the Seal Vinyl (C 956 C). It should meet the Door

Strike (931 M) to magnetize, keeping your door closed.

7. Slide the rest of the Seal Vinyl (C 956 C) in the Vinyl Strike Post

(C 180 C), on top of the Magnet (98-45), then, trim the excess at

the top to be ﬂush with the Vinyl Strike Post (C 180 C).

C 180 C