Instructions / Assembly

ManualsBrandsCoastal Shower Doors ManualsBathLegend Series 53 in. x 69 in. Framed Hinge Swing Shower Door with Inline Panel in Oil Rubbed Bronze with Clear Glass

Frame Assembly (C) should be pushed up against Wall Jamb (A).

Panel Assebly (B) should in turn be pushed up against Frame

Assembly (C).

Now step inside the shower enclosure and secure the unit to the

remaining shower wall by telescoping the Inline Panel Assembly

side Wall Jamb (D) up against the shower wall as shown. Secure

Wall Jamb (D) with three Installations Screws (E).

Finish securing the Frame and Panel Assemblies. Use three

Adjustment Screws (G) to secure Wall Jamb (A) to Frame Assembly

(C). Next use three Adjustment Screws (G) to secure Panel

Assembly (B) to Frame Assembly (C).

figure 5

figure 6

Measure opening width at top of unit and trim Header (H) to length

minus 1/16 of an inch. Position Header (H) into place as shown in

figure 6 above and secure utilizing three (3) self drilling screws (G).

TO ENSURE A LEAK PROOF INSTALLATION:

Run a bead of clear mildew resistant caulking around the outside of

shower enclosure where shower unit meets the shower base and

where Wall Jambs meet the wall. Follow caulking manufacturer's

instructions before using shower.

STEP 5

Insert Inline Panel Wall Jamb and Position Inline Panel

STEP 6

Install Header and Caulk outside of Unit.

figure 4

Detail shows strike on wall side / pivoting at panel,see also exploded view on sheet 2

With the installation holes on the same side as the panel's adjust-

ment holes (see figure above), insert the Inline Panel Wall Jamb (D)

into the Inline Panel's Expander Jamb (b2) as shown. Bury the Wall

Jamb into the Panel as far as it will go.

Lift Panel Assembly onto base ledge and position the Panel's

Expander Jamb (b2) over the Door Frame's vertical post (c2) . . .

insert Panel Assembly (B) onto Door Assembly (C) as far as it will

go.

Double check to make sure that the shower assembly is centered

and squared on the base curb.

STEP 4

Insert Inline Panel Wall Jamb and Position Inline Panel

STEP 3

Install Door Assembly

figure 3

Detail shows strike on wall side and pivoting at panel,see exploded view on sheet

2 also. Cartwheel the door assembly 180 degrees if you want strike on panel side

and pivoting on wall side.

Lift Door Assembly onto base ledge and over the CHSL-KIT

Assembly (J), then slide the Door Frame (C) into Wall Jamb (A).

Whether the door strikes at wall side or pivots at wall side, always

double check to make sure that the door swings out.

Leave door assembly there temporarily and do not fasten at this

time.