Legend ( continuous hinge ) (1) Legend Continuous Hinge_05-01-2015
LEGEND CONTINUOUS HINGE UNIT (EXPLODED VIEW) PARTS LIST PART K EY LE TTE R A B C NUMBER 98 404WJ 442 DESCRIPTION QUANTITY SILL ............................................................ 1 WALL JAMB ............................................. 2 STRIKE JAMB ......................................... 1 D d1 d2 d3 d4 d5 d6 d7 d8 ---227 154 226 443 98-42 C 173 B 6112FSHL C P 156 DOOR ASSEMBLY ................................. Door Rails .................................................
Measure opening width and trim sill to 1/16” less than measurement obtained. Caulk underside of sill and position it on center of curb. Insure that sill lip faces toward outside of enclosure. Position Jambs on sill, mark and drill 3/16” installation holes on walls. Insert Screw Anchors into holes and secure Wall Jambs to walls with 1-1/2” Installation Screws Provided. Note that adjustment holes are toward interior.
Close door and let magnets on Door and Strike Post meet. Adjust unit Measure Door width as shown and trim Vinyl Sweep to 3/8” less then as required making sure a parallel alignment is maintained between measurement obtained. Notch one end of Vinyl Sweep one quater inch bottom of Door Assembly and Sill. When satisfied with alignment, (approximate) as shown. secure Door Assembly and Strike Post to Wall Jambs. Insert Vinyl Sweep into Door Vinyl Slot as shown.
