Instructions / Assembly

( 4 )
LCH_04-20-2015
Measure Door width as shown and trim Vinyl Sweep to 3/8” less then
measurement obtained. Notch one end of Vinyl Sweep one quater inch
(approximate) as shown.
Close door and let magnets on Door and Strike Post meet. Adjust unit
as required making sure a parallel alignment is maintained between
bottom of Door Assembly and Sill. When satisfied with alignment,
secure Door Assembly and Strike Post to Wall Jambs.
Finally, caulk outside where unit meets the curb and where unit meets
the shower walls as shown. Follow caulking manufacturer’s instruc-
tions before using shower.
Insert Vinyl Sweep into Door Vinyl Slot as shown. Slot is located on
hinge side of the Door Assembly.