Specification

10185-8
11. Hinge and pivot bushings shall be self-lubricating nylon 6/6 with stainless
steel wear washers.
12. Doors shall have continuous drip rail and vinyl wiper blade at bottom of panel.
Framed Paragon units shall have aluminum drip rail sloped to drain water to
the interior of the door when opened. Drip rail ends shall have plastic
protective caps at both ends for safety.
13. Latch to be permanently mounted magnetic strips for framed doors.
Frameless doors shall have a special plated Neodymium magnet that fits into
the strike jamb and a special stainless steel strike plate that is attached to the
door handle. Mechanical closure devices not permitted.
14. Adjustable jamb to provide +/- 5/16 inch (8 mm) adjustment.
15. Pull handle shall be extruded aluminum finished to match the unit.
16. Pull handle shall be polished aluminum handles that mount through drilled
holes in the glass.
17. Units shall have continuous curb with weep slots to drain any infiltrated water
to the interior of the unit.
18. Fixed glass panels shall be flush-glazed and held in place with roll-in vinyl.
19. Walls jambs on stand-alone doors shall be covered with black plastic caps for
safety.
D. Paragon 3/8 Series:
1. Glass: 3/8 inch (9 mm) clear with polished edges. Cut outs per drawings for
wall hinge.
2. Finish: Polished Chrome plated brass.
3. Finish: Brushed Nickel plated brass.
4. Finish: Oil Rubbed Bronze plated brass.
5. All hardware shall be finished to match hinge assemblies.
E. Illusion Series:
1. Glass: 1/4 inch (6 mm) clear glass for door panel with polished edges; 3/8
inch (9 mm) glass for all additional panels.
2. Finish: Brite Silver anodized aluminum.
3. Finish: Brushed Nickel anodized aluminum.
4. Finish: Oil Rubbed Bronze anodized aluminum.
5. Frameless doors shall have a special plated Neodymium magnet that fits into
the strike jamb and a special stainless steel strike plate that is attached to the
door handle. Mechanical closure devices not permitted.
6. Adjustable jamb to provide +/- 5/16 inch (8 mm) adjustment.
7. Polished aluminum handles that mount through drilled holes in glass.
8. Walls jambs on panels shall be covered with black plastic caps for safety.
2.5 MATERIALS AND CONSTRUCTION
A. Extruded Aluminum Alloy:
1. Headers:
a. Brite Extruded aluminum shall be 6463-T6 alloy.
b. Satin Extruded aluminum headers shall be 6063-T6 alloy.
2. All Other Extrusions:
a. Brite Extruded aluminum shall be 6463-T5 alloy.
b. Satin Extruded aluminum shall be 6063-T5 alloy.
B. Aluminum Finish: Finish shall conform to the following Aluminum Association
Specifications.
1. Silver:
a. AA-M11-C31-A21 for Brite Anodized Aluminum.
b. AA-M22-C31-A21 for Polished Brite Anodized Aluminum.
2. Gold: