Specification

10185-9
a. AA-M11-C31-A23 for Brite Anodized Aluminum.
b. AA-M22-C31-A23 for Polished Brite Anodized Aluminum.
3. Brushed Nickel:
a. AA-M35C32A44
4. Oil Rubbed Bronze:
a. AA-M10C22A44
C. Fasteners:
1. Screws and fasteners shall be stainless steel to prevent rust and corrosion.
D. Glazing Materials:
1. Glazing materials shall be safety tempered glass with a nominal thickness of
0.125 inch (3.18 mm), 0.156 inch (3.96 mm) or 0.188 inch (4.78 mm) on
obscure and clear framed panels, 0.188 inch (4.78 mm) or 0.25 inch (6.35
mm) or 0.375 inch (9.5 mm) on obscure and clear frameless panels. ANSI
Z97.1 and / or 16 CFR 1201 shall be stamped on the glass.
PART 3 EXECUTION
3.1 EXAMINATION
A. Do not begin installation until substrates have been properly prepared.
B. If substrate preparation is the responsibility of another installer, notify Architect of
unsatisfactory preparation before proceeding.
3.2 PREPARATION
A. Clean surfaces thoroughly prior to installation.
B. Prepare surfaces using the methods recommended by the manufacturer for
achieving the best result for the substrate under the project conditions.
3.3 INSTALLATION
A. Comply with manufacturer's written installation instructions.
B. Install securely and in proper relationship with adjacent construction.
C. Install straight and plumb.
D. Test and adjust for proper operation.
3.4 PROTECTION
A. Protect installed materials from damage from construction operations.
B. Repair or replace damaged units.
C. Protect installed products until completion of project.
D. Touch-up, repair or replace damaged products before Substantial Completion.
END OF SECTION