Installation & Assembly

“ILLUSION” FRAMELESS SHOWER ENCLOSURE

INSTALLATION INSTRUCTIONS

Need some help? Call our customer service team at 1-800-874-8601

STEP 11. INSTALLING THE DOOR HANDLE

STEP 12. INSTALLING DRIP RAIL

1. Insert the two clear plastic bushings into the

holes on the glass.

2. Slip a washer (K2) onto the screw (K1).

3. From inside the shower, insert the screw through

the bushing hole, then, slide a washer onto the

screw (on the exterior side of the door).

4. Hand tighten the screw into the Handle (C-5313-

8), then use the ﬂathead screwdriver to tighten

further.

IMPORTANT: Don’t tighten beyond a comfortable

tension, or you risk damaging the door.

5. Complete the installation by tightening the two

set screws (K4) into the interior handle.

1. Position drip wing toward interior of shower, and insert Drip Rail

(C 914 C) onto the bottom edge of the door.

2. Trim as required using a straight edge. Test door closure and ensure

vinyl sweep ﬁts inside Dam Sill (CST 901). Snap in when door is closed.

Door Hinge

C 914 C

CST 901

C 914 C

Trim as required and notch

9/16” to ﬁt into Vinyl Strike

C 180 C when door is closed