Installation & Assembly

6
“ILLUSION” FRAMELESS SHOWER ENCLOSURE
INSTALLATION INSTRUCTIONS
Need some help? Call our customer service team at 1-800-874-8601
IMPORTANT: All Coastal Shower Doors are pre-assembled for left-side configuration. To convert to right-
side configuration, follow the steps below:
You’ll notice two holes just above the top and bottom hinge pins. These are pre-cut for right-side door
configurations.
To convert your door to a right-side configuration, remove the screws from the pins, then install them into the
other holes. This will cause your door to stick up 5/8” at the top. Simply rotate your door 180 degrees, as if
you were correcting an upside-down photograph, with the hinge on the right side.
Your door should now open to the exterior of the shower enclosure, completing the right-side configuration.
RIGHT-SIDE CONFIGURATION
Hinge On Left Side Hinge On Right Side
Follow the steps below to change into
Flip 180°
Make sure the
new hinge position
works properly