Specifications Sheet

3
Legend Inline 04-28-2011
figure 1
STEP 1
Position Door Assembly Side Wall Jamb
Determine and mark the curb centerline as shown
in figure 1.
Decide which configuration best suits your needs
door assembly on left / inline panel on right
OR
inline panel on left / door assembly on right
Your choice (of door location above) will deter-
mine which wall you will attach the 404 wall jamb
to.
With adjustment holes facing toward the interior
of enclosure, position Wall Jamb (A) up against
the shower wall . . . and center it on the centerline
mark. Use a level to plumb the Wall Jamb. Using
the Wall Jamb's installation holes as guides, drill
three 1" deep installation holes on the wall.
Use a 3/16" masonry bit when drilling through
ceramic tile, marble or any masonry type sur-
face. Insert Plastic Screw Anchors (F). Other-
wise use a regular 1/8 drill bit and discard Plastic
Anchors. Secure Wall Jamb with three (3) #8 x
1-1/2" pan head screws (E).
figure 2
figure 2a
STEP 2
Measure Door Assembly width, then position and secure CHSL-KIT on curb base
Measure the width of Door Assembly (C) as shown in figure 2, then mark the CHSL-KIT (J) location as shown in figure 2a. Please note that Vinyl
Bushing (j2) IS NOT centered on the centerline, but is located tangent and to the outside of the centerline as shown in figure 2a. Secure Nylon
Bushing (j2) to curb base using the #6 Flat Head Phillips Screw (j1) provided.