User Manual

Find more ideas & inspiration: redheart.com
©2017 Coats & Clark
Page 1 of 2
Simple Lace Triangle
Shawl
RED HEART® Super Saver
Ombre ™: 1 skein 3961 Scuba
Susan Bates® Circular Knitting
Needle: 5mm [US 8], 40" [101
cm] long
Stitch markers, yarn needle
GAUGE: 15 sts = 4" [10 cm];
22 rows = 4" [10 cm] in Eyelet
Stripe stitch. CHECK YOUR
GAUGE. Use any size needles
to obtain the gauge.
RED HEART® Super
Saver Ombre™, Art
E305 available in
print colors 10 oz (283 g),
482 yd (440 m) skeins
LM5441
knitting
Designed by Cathy Payson
What you will need:
BUY YARN
This classic shawl is a perfect way to keep
your shoulders warm in chilly rooms. The
pattern is easy to stitch, and the ombré
stripe effect knits up beautifully.
Shawl measures 72" [183 cm] at widest
point x 24" [61 cm] at longest point.
NOTE
Shawl is worked back and forth in rows.
Circular needle is used to accommodate
large number of stitches.
SHAWL
Cast on 5 sts.
Row 1 (Right Side): K1, yo, k1, yo, place
marker, k1, place marker, yo, k1, yo, k1 –
9 sts.
Row 2: Knit.
Row 3: K1, yo, knit to marker, yo, slip
marker, k1, slip marker, yo, knit to last st,
yo, k1 – 13 sts.
Row 4: Knit.
Repeat Rows 3-4 three more times –
25 sts on last row worked.
Row 11: K1, yo, knit to marker, yo, slip
marker, k1, slip marker, yo, knit to last st,
yo, k1 – 29 sts.
Row 12: K1, purl to last st, k1.
Repeat Rows 11-12 two more times –
37 sts on last row.
Row 17 (RS): K1, yo, k1, [yo, k2tog] to
marker, yo, slip marker, k1, slip marker,
[yo, k2tog] to last 2 sts, yo, k1, yo, k1 –
41 sts.
Row 18: Repeat Row 12.
Repeat Rows 11-18 until piece measures
23½" [60 cm] from beginning and 269
sts are on last row worked, end with
Row 11.
Next Row (Wrong Side): Knit.
Next Row: K1, yo, knit to last st, yo, k1 –
271 sts.
Bind off knitwise on last wrong side row.
FINISHING
Weave in ends.
To block, pin piece out to measurements
and spray with water. Leave to dry.
Abbreviations
cm = centimeters; k = knit; k2tog = knit
2 sts together; mm = millimeters; st(s)
= stitch(es); tog = together; yo = yarn
over; [ ] = work directions in brackets
the number of times specified.
See next page for alternate photos