System information

16
5.1
CHANNEL INSTALLATION (DO NOT USE UNLESS INSTRUCTED TO BY CABLE SUPPORT)
The Installation menu in the System Setting menu is used for searching channels. Select the Installation
menu option in the System Setting menu. Press the OK button and the Installation menu will be
displayed, as shown below. NOTE: Doing any of the below can leave STB with NO channels!
Figure 5-2 CH search menu
The Search mode includes NIT Search, Auto Search and Manual Search. Press
←
or
→
to select the
installation mode. NOTE: If you see black bars – there is NO signal to STB.
5.1.1 NIT Search (Use this and change to frequency provided - 079000)
The NIT Search will find the NIT table in the network, then search all the valid channels set by provider.
This is the ONLY way for searching to restore channels.
5.1.2 AUTO Search (DO NOT USE)
The Auto Search allows you to set the first channel center frequency and the last channel center
frequency, as well as the frequency step between two channels. Then the STB decoder will scan all the
channels in the range by the step of the BW which you setting.
5.1.3 Manual Search (DO NOT USE)
WARNING: The Manual Search should be used for test purposes. Otherwise, the order of the channel
sorting will be different from the operator’s channel map. CALL 734-1424 if you have any questions
The operation of Manual Search is the same as the NIT search.
5.2 CH M
ANAGER
The CH Manager menu option provides management of the channels stored in STB, The CH Manager
function is described in the table below: NOTE: Doing any of the below can leave STB with NO channels!
TV Favorite Set, Enable/Disable Channel
and Adjust Channel position
Radio The operation and function is same as
TV
Delete all Delete all channel in STB