User manual

iNetVu™ 5000 Controller User Manual Page 16 of 77

6. Installation

The iNetVu™ 5000 Controller is shipped pre-configured for the iNetVu™ Mobile Platform

and service which you plan to use, and only configuration of Satellite Modem / VSAT

Communication parameters and the satellite you wish to find are required.

6.1. Setup

1. Connect all of the cables and components as depicted by the previous section.

2. Power on the PC and the iNetVu™ 5000 Controller.

3. Run the iNetVu

5000 Software

4. Advance to the Controls Screen and ensure that all the status panel indicators

are green.

5. To configure the Satellite Modem / VSAT Communication Parameters, go to the

Configuration Screen and configure as required for the type of service you are

using, and click save. This will be specific to the service that you are using.

6. To configure the Target Satellite, go to the Maintenance Screen, and enter the

Satellite Name, Longitude, and Tx Polarity (Sat Pol Offset: 0 – Vertical, 90 –

Horizontal), and click save.

7. Go to Controls Section, and ensure that ALL System Status Panel Indicators are

green.

8. That’s it. You have successfully completed the installation and setup of the

iNetVu™ 5000 Controller and are ready to find satellite.