Operating instructions

CPS:Doc 20017 V1 24/01/2012 Page 7 Issue 1 24/01/2012
Front Panel Controls
Output Set
The control sets the output power, provided the unit is in “local power set”
mode, meaning the remote power switch is in the down position and the remote
power link is not made in the remote control connector.
RF On and Off switches:
The switches turn the RF output on and off, provided the unit is in “local on/off”
mode, meaning the remote on switch is in the down position and the remote
on/off link is not made in the remote control connector. The RF off switch is also
used to reset a latched interlock condition when the unit is in “local on/off”
mode, and to reset the initial “splash screen”.
Remote control of RF On/Off:
Operating this switch locks out the RF on and off switches on the front panel so
that RF is activated by a circuit on the remote connector.