User manual

Chapter 5: Server Management
164 Cobalt RaQ XTR User Manual
Veritas NetBackup
To configure the Veritas NetBackup backup and restore solution:
1. Select Server Management > Backup and Restore > Veritas NetBackup.
The “Veritas NetBackup Backup Settings” table appears. See Figure 81.
2. Enter the following information:
• Enable Client—Click the check box to enable the Veritas NetBackup
backup client.
• Master Veritas Server—Enter the fully qualified domain name of
Veritas NetBackup master backup server. The Veritas master backup
server must have a valid host name.
• Extra Veritas Servers—Enter the fully qualified domain names of any
extra Veritas NetBackup backup servers. All Veritas servers must have
valid host names.
3. Click Save. The table refreshes and displays the new configuration.
To configure the Veritas NetBackup backup server, see Appendix F, “Disaster
Recovery with Third-Party Software”.
Figure 81 shows the “Veritas NetBackup Backup Settings” table.
Figure 81. Veritas NetBackup Backup Settings table