User manual

Using the LCD Console
43
2. Press the Select button once until REBOOT appears in the
LCD display:
SELECT:
REBOOT
3. Press the Enter button.
4. Use the cursor control keys to toggle the cursor between
[Y] and [N]. Select [Y] to reboot the system and then
Enter.
Note: You can also reboot via the browser. To do this, go to the
Server Management screen, click Maintenance, and then click
Reboot (at the top of the screen). In the table that appears,
click Reboot.
Powering Down
!
Caution: To prevent the potential loss of data, it is important to
follow the proper power-down procedure (described below)
before turning off the NASRaQ.
To select the power-down application:
1. From the LCD console, press and hold down the Select
button for approximately 2 seconds.
The LCD screen displays:
SELECT:
SETUP NETWORK
2. Press the Select button twice until POWER DOWN appears in
the LCD display:
SELECT:
POWER DOWN
3. Press the Enter button.
4. Use the cursor control keys to toggle the cursor between
[Y] and [N]. Select [Y] to power down the system.