User manual

Chapter 5: Administration Site
164 Cobalt Qube 3 User Manual
• IP Address (Primary Interface). Enter the IP address of the primary
interface. If you are using only one network interface connection to the
server appliance, use the primary interface and leave the secondary
interface empty. Enter a series of four numbers between 0 and 255
separated by periods. For example, 192.168.1.1 is a valid entry.
• IP Network Mask (Primary Interface). Enter the network mask of the
primary interface. If you are using only one network interface connection
to the server appliance, use the primary interface and leave the secondary
interface empty. Enter a series of four numbers between 0 and 255
separated by periods. For example, 255.255.255.0 is a valid entry.
• MAC Address (Primary Interface). The Media Access Control (MAC)
address is the hardware address of the network interface card. This
hardware address is a unique identifier and cannot be changed after
manufacture.
• IP Address (Secondary Interface). Enter the IP address of the secondary
interface. If you are using only one network interface connection to the
server appliance, use the primary interface and leave the secondary
interface empty. Enter a series of four numbers between 0 and 255
separated by periods. For example, 209.43.21.5 is a valid entry.
• IP Network Mask (Secondary Interface). Enter the network mask of the
secondary interface. If you are using only one network interface
connection to the server appliance, use the primary interface and leave
the secondary interface empty. Enter a series of four numbers between 0
and 255 separated by periods. For example, 255.255.255.0 is a valid
entry.
• MAC Address (Secondary Interface). The MAC address is the hardware
address of the network interface card. This hardware address is a unique
identifier and cannot be changed after manufacture.
3. Click Modify Static Routes. The Static Route List table appears; see
Figure 81.
Figure 81. Static Route List table