User manual

Appendix A: Using the LCD Console
196 Cobalt Qube 3 User Manual
Set up network
To reset the IP address or change the network configuration of the primary
network interface:
1. On the LCD console, hold down the button for approximately two
seconds. The LCD screen displays:
SELECT:
SETUP NETWORK
2. Press the button.
3. Enter the IP address of the primary network interface using the arrow
buttons. The left and right arrow buttons move the cursor position to the left
or right. The up and down arrow buttons increase or decrease the digit at the
cursor position.
4. Press the button.
5. Enter the Netmask of the primary network interface using the arrow buttons.
6. Press the button.
7. Enter the Gateway using the arrow buttons.
8. Press the button.
9. Use the arrow buttons to toggle the cursor between [S]ave or [C]ancel.
10. Press the button.
If you select Save, the Qube 3 saves the new information. The LCD screen
returns to the normal display with the fully qualified domain name on the top line
and the IP address on the bottom line.
If you select Cancel, the LCD screen just returns to the normal display.
You can also change the network configuration of the Qube 3 through the Web
browser:
1. On the Server Desktop, select Administration > System > TCP/IP . The
TCP/IP Settings table appears.
2. Edit the network settings in the tables.
3. Click Save .